Power Tailgate Conversion Kit for the GAC Aion i60 (2026)

The Aion i60 leaves the factory with a manual rear door. This conversion set replaces both gas struts with driven actuators and adds a self-learning control unit, so the boot opens from the key, the cabin switch or a foot gesture, then closes itself with a soft final pull.

Design Details

• Driven actuators – ball-stud mounted units with internal hall sensing, sealed against dust and road spray (IP54).
• Self-learning module – learns the door travel on first power-up, so no laptop or diagnostic tool is needed at the workshop.
• Five control channels – factory remote, cabin button, tailgate handle, added dash button and optional kick sensor.
• Soft close latch – the last stage is motor-damped, removing the slam that wears out factory latches.
• Obstacle detection – current signature monitoring reverses the door within 0.3 seconds of resistance.
• Park interlock – commands are ignored unless the selector sits in P.
• Height programming – four stored positions suit garages, car washes and low canopies.

Fitment Matrix

Mounting points follow the factory hinge and striker locations. Original latch, central locking and alarm behaviour stay unchanged.

Specifications

• Voltage: 12V DC, 10A circuit
• Actuator stroke: matched to i60 door geometry
• Ball stud: 10 mm
• Full open time: 6 to 9 seconds
• Standby draw: under 3 mA
• Ingress protection: IP54
• Cycle tested: 50,000 open/close
• Warranty: 24 months

Testing & Quality Control

Every actuator is run in both directions on a load rig and checked for current, noise and end-stop accuracy. Modules are flashed and verified against the correct firmware for the i60 body controller. Finished sets are packed after a full system simulation, and cartons are dropped from 80 cm on corner and edge faces before shipment.

Ordering Information

Sold per set, one vehicle per set. Mixed containers are accepted; the foot sensor version is packed with a separate sensor carton. Neutral boxes and customer-branded boxes are both available, and OEM labelling can be arranged for orders above 50 sets.